Quantcast
Channel: Trout flies – FrankenFly
Viewing all articles
Browse latest Browse all 422

Mercer’s Skating October Caddis SBS – Scott Patterson

$
0
0

This is Mercer’s Skating October Caddis with a few minor changes to the original pattern.
Tied by Scott Patterson and photos by Scott Patterson

hook – TMC 5263 #6
thread – UTC 140 tan
rib – x-fine wire copper
underbody – Mirage Tinsel opal
body – Midge Tubing amber
body hackle – brown (undersize by 2)
thorax – Ice Dub hare’s ear
underwing – deer hair orange
overwing – Congo Hair orange
lower lip – 2mm foam tan
upper lip – 2mm foam orange
legs – small rubber orange

m921 mash barb, start thread at 2/3 mark; tie in rib and wrap to bend tie in tubing tie in tinsel at 2/3 mark; wrap to bend, leave tag end hanging m4 wrap tubing forward to 2/3 mark; tie off/trim spiral tag end of tinsel forward; tie off/trim  (original used the tinsel rib to add a little flash to the pattern, but using it under the midge tubing adds enough flash to make this extraneous - next time I'll leave this step out) tie in hackle; wrap to the bend m8 capture tip with wire; continue rib thru the hackle to the 2/3 mark, helicopter end, cover with thread, trim hackle tip m910 tie in lower foam strip (gap width); wrap to eye repeat with the upper dub thread/dub thorax m914 clean, stack, measure (tips to bend) a clump of deer hair; trim butts/tie in m916 tie in a clump of Congo Hair, tips even with underwing; trim butts m918 tie in legs cover tie in with a little more dubbing; half hitch x 2, SHHAN trim legs/foam m922 m923

Viewing all articles
Browse latest Browse all 422

Trending Articles